Paramount Paralevel 2011 Start Up Kit

The Paralevel is designed to control the water level in a swimming pool or spa. The "Posi-Click" control makes adjusting the water level very easy. Four clicks (or one revolution) of the adjustment wheel changes the water level by 1/4 inch. The Paralevel uses "Smart Sensing", eliminating rapid cycling of the device even when the pool is being used. The user can use 1-1/2 inch or 2 inch pipe for the balance line. The water line can be plumbed with 1/2 inch or 3/4 inch pipe. The Paralevel can also be plumbed with 2 inch pipe for overflow protection, offering the highest overflow protection in the industry.

Using new float in an older tank:
1. While holding the new float, twist sleeve counter clockwise until it comes out of the float.
2.Turn float over and re-thread on sleeve with flat side up. Be careful not to cross-thread. (Fig. 12)
3.Compare the float height on the sleeve to the old float. The new style float will need to be approximately 5/8 inch lower on the sleeve to achieve a similar water level. (Fig. 13)
4.Install in the housing and turn on the water supply.
5.If the float is off, shut off the water and remove the float and turn in the direction indicated on the flat side of the float to raise the water level 1/8 inch, one half turn, or 2 posi-clicks. Follow the arrows on the float. (Fig. 14)
6.If the float is on, shut off the water and remove the float and turn in the direction indicated on the flat side of the float to raise the water level 1/8 inch, one half turn, or two (2) posi-clicks. Follow the arrows on the float. (Fig. 14)
7.Repeat steps 5a or 5b until water level is matched.
8.Check pool level after a few days to verify correct set level.

Part# 004-760-2921-00