HomeIdentify Your SystemPool Valet Nozzle
Pool Valet Nozzle
Pool Valet Nozzle

The Pool Valet Nozzle is manufactured by Paramount Pool Systems. Each hole on the pool valet is either 1/4 inch or 3/8 inch. The nozzle comes with 4 partial holes in it. Only one or two are drilled out all the way. The nozzle can be ordered as a blank and it is left to the installer to drill out the proper holes.

*Note: Blank nozzles will cause the pump to dead head out if you do not drill out the hole in the nozzle.

Broken Pool Valet Nozzles:
  • Remove the nozzle threaded ring with the metal hand tool.Then replace the nozzle with a new nozzle that has the same size hole. When a nozzle breaks there is usually a reason and most of the time it is because debris has plugged one or more of the nozzles in that circuit so check all nozzles on the circuit(zone)for debris.
  • If the threaded part of the body in the plaster is broken it can be repaired with a pool valet retro kit.

    Click Here to order Replacement Part for the Paramount Pool Valet system.